Manufacturer-documented model guide
Anker SOLIX C1000 Gen 2
May fit: Selected 120 V loads after checking running watts and startup demand.
Consider another setup: 240 V loads, over 2,000 W output, or battery-expansion needs.
Manufacturer research; no hands-on testing. Source records checked on 2026-10-04.
The SOLIX C1000 Gen 2 pairs 1,024 Wh of listed capacity with 2,000 W rated 120 V output and up to 600 W solar input. It is heavier and slightly lower-capacity than the Explorer 1000 v2, with a manufacturer-listed 10 ms UPS transfer figure and no expansion capacity in Anker's comparison table.
- Continuous AC output
- 2,000 W — source for Continuous AC output, checked 2026-10-04 (opens in a new tab)
Quick answer
Start with your household’s power needs
Identify each appliance’s running watts, startup demand, voltage and operating time. Compare those needs with documented output and capacity, allowing for conversion losses and changing conditions. Rated capacity does not predict exact runtime.
Check planned loads in the backup-power selectorUse the Gen 2 specifications, not the original C1000 figures
Anker lists C1000 Gen 2 at 1,024 Wh, 2,000 W maximum rated AC output, three AC output ports, 120 V, 600 W maximum solar input, 24.9 lb, and 15.12 × 8.19 × 9.61 in. Confirm the exact Gen 2 model and bundle before purchase; similarly named C1000 versions have different specifications.
Choose by the load and the recharge plan
The listed capacity is slightly below the Explorer 1000 v2's 1,070 Wh, while rated AC output and solar input are higher. Those specifications answer different questions: watt-hours concern stored energy, watts constrain the loads that can run together, and solar input is only a ceiling. Estimate daily energy and appliance starting demand, then confirm charging conditions and compatible panels. No specific runtime is promised.
Do not use SurgePad as a general surge rating
Anker's U.S. manual describes SurgePad for up to 2,400 W and says it works better with heat-generating devices. It does not support precision instruments or other devices with strict voltage requirements, and it is unavailable in bypass mode. This feature does not establish that a refrigerator, pump, compressor, or other motor will start. Check the appliance and follow both manufacturers' instructions; the product page's separate 3,000 W peak figure is not used here as an everyday or general motor-start rating.
Check the transfer requirement and expansion plan
The U.S. manual lists 10 ms UPS switching. Verify that every connected device can tolerate that interruption; a UPS label is not a guarantee for every motor, computer, or critical device. Anker's product comparison table lists no expandable capacity, so plan around the base station rather than assumed battery add-ons. Neither the 10 ms figure nor the capacity makes this a whole-home backup system.
Verified source record
Manufacturer specifications used in this guide
Each figure links to the product page or manual used for that field, with its own check date. Manufacturer specifications are not independent performance measurements. Source records checked on 2026-10-04. We have not tested this model hands-on.
- Nominal capacity
-
1,024 Wh
Checked 2026-10-04. Source for Nominal capacity (opens in a new tab)
- Battery chemistry
-
Not verified in this source record
Chemistry was not verified in the reviewed U.S. primary sources.
Checked 2026-10-04. Source for Battery chemistry (opens in a new tab)
- Continuous AC output
-
2,000 W
Rated maximum; check actual load and operating mode.
Checked 2026-10-04. Source for Continuous AC output (opens in a new tab)
- Surge output
-
Not verified in this source record
No general surge rating entered: manual describes SurgePad up to 2,400 W with limits; the product page separately markets 3,000 W peak.
Checked 2026-10-04. Source for Surge output (opens in a new tab)
- US AC outlet count
-
3 outlets
Three AC output ports shown in the official product overview.
Checked 2026-10-04. Source for US AC outlet count (opens in a new tab)
- 240 V AC output
-
No
U.S. AC output is listed at 120 V.
Checked 2026-10-04. Source for 240 V AC output (opens in a new tab)
- Maximum solar input
-
600 W
Checked 2026-10-04. Source for Maximum solar input (opens in a new tab)
- Maximum documented expanded capacity
-
Not verified in this source record
The manufacturer comparison table lists expandable capacity as No.
Checked 2026-10-04. Source for Maximum documented expanded capacity (opens in a new tab)
- Transfer / switching time
-
10 ms
UPS supports 10 ms switching.
Checked 2026-10-04. Source for Transfer / switching time (opens in a new tab)
- Base-unit weight
-
24.9 lb
Checked 2026-10-04. Source for Base-unit weight (opens in a new tab)
- Listed warranty term
-
Not verified in this source record
Warranty term was not verified in the reviewed U.S. primary sources.
Checked 2026-10-04. Source for Listed warranty term (opens in a new tab)
- The manual describes SurgePad up to 2,400 W, says it works better with heat-generating loads, does not support precision instruments or strict-voltage devices, and does not operate in bypass mode. Do not use this as a general motor-start or surge rating.
- The 10 ms UPS figure does not establish compatibility with every computer, motor, refrigerator, medical device, or other load; verify interruption tolerance and test safely.
- The manufacturer comparison table lists no expandable capacity. The 600 W solar rating is a maximum input ceiling, not an expected charging rate.
- No model-specific chemistry or warranty term was verified in the reviewed U.S. sources; those values are intentionally blank.