Manufacturer research Specifications checked 2026-11-12 US model

Tripp Lite Isobar 6-Outlet Surge Protector (ISOBAR6ULTRA)

A heavy-duty all-metal 6-outlet surge suppressor rated at 3,330 Joules with 3 isolated EMI/RFI filter banks (up to 80 dB noise attenuation) and automatic permanent shutoff upon protection loss.

Outlets and filter banks
6 NEMA 5-15R outlets arranged in 3 exclusive isolated filter banks
EMI/RFI noise filtering
Up to 80 dB EMI/RFI line noise filtering
See all specifications and sources

Is it right for your household?

Where it fits

Protecting refrigerators, gas furnace controls, networking gear, and home office hardware during post-outage grid restoration spikes.

When to consider another option

Maintaining continuous runtime during a blackout or deep brownout — pair a pure sine wave UPS where battery holdover is required.

More fit considerations

Other situations to consider

  • Workstations needing isolated filter banks so motor noise on one outlet bank does not bleed into audio or sensitive electronics.
  • Locations requiring widely spaced NEMA 5-15R outlets for bulky AC wall adapters.

Other reasons to choose a different setup

  • Continuous 15A heating or motor loads exceeding the 12A (1,440W) resettable circuit breaker limit.
  • Whole-panel service-entrance Type 1/Type 2 lightning surges — install a licensed panel SPD alongside point-of-use suppressors.

Manufacturer specification record · No hands-on testing · Source records checked on 2026-11-12

Point-of-use defense for grid-return transients

When utility crews re-energize storm-damaged feeders, switching transients and voltage spikes routinely damage electronic control boards. Exceeding IEEE 587 Category A and B surge benchmarks, the 3,330-Joule ISOBAR6ULTRA absorbs point-of-use spikes and includes diagnostic LEDs plus automatic permanent outlet shutoff if internal varistors are expended.

Isolate heavy appliances within 12A limits

Keep total draw under 12A (1,440W on 120V circuits), avoid daisy-chaining power strips, and use the three isolated filter banks to separate noisy transformer bricks from sensitive routers or medical monitoring equipment.

Specifications & sources

These are manufacturer specifications, not independent performance measurements. Source records checked on 2026-11-12. We have not tested this model hands-on.

Surge protection rating

3,330 J

3,330-joule surge suppression exceeds IEEE 587 Category A and B surge specifications.

Checked 2026-11-12. Source for Surge protection rating (opens in a new tab)

Outlets and filter banks

6 NEMA 5-15R outlets arranged in 3 exclusive isolated filter banks

Widely spaced outlets accommodate transformer plugs; isolated filter banks prevent connected equipment interference.

Checked 2026-11-12. Source for Outlets and filter banks (opens in a new tab)

EMI/RFI noise filtering

Up to 80 dB EMI/RFI line noise filtering

All-metal housing shields electronics against electromagnetic and radio-frequency line noise.

Checked 2026-11-12. Source for EMI/RFI noise filtering (opens in a new tab)

Circuit breaker and cord

12A resettable circuit breaker; 6 ft. (1.8 m) cord with right-angle NEMA 5-15P plug

120V AC nominal input, 50/60 Hz compatibility.

Checked 2026-11-12. Source for Circuit breaker and cord (opens in a new tab)

Safety shutoff and diagnostics

Automatic permanent shutoff and diagnostic LEDs (protection present, line fault, line OK)

Permanently cuts power to outlets if surge protection circuitry is compromised.

Checked 2026-11-12. Source for Safety shutoff and diagnostics (opens in a new tab)

Research notes & original documents